- The function introduction of three screw granulator
- How to look at the future development of the three screw extruder
- Structural features of three screw granulator
- General failure of three screw extruder and its elimination method
- Instructions for the use of three screw extruder
- The difference between a single screw granulator and a twin screw granulation machine
- Several points for attention in selecting plastic pelletizer
- Summary of screw knowledge parameters of twin screw granulator
- Three screw extruder granulation machine granulator appear black spots how to do
- The principle and fault maintenance of the granulator
- How to do the high temperature of the waste plastic granulator at work
- What do you need to pay attention to when using the three screw pelletizer
Shijiazhuang Xi Rong Machinery Co., Ltd.
地址:Shijiazhuang City West Development Zone of Wuji County
传真:0311-86504778
手机:13102889793
联系人:Manager Wang
邮箱:wlh88888888@163.com
How to improve one of the most common problems in three screw granulation machining
Shrinkage of three screw pelletizer is one of the most common problems in plastic granulating machine.
Shrinking is a tricky problem!
Therefore, with the continuous improvement of the machining process of the three screw granulator, in order to minimize the shrinkage of the plastic granulating machine and improve the quality of the product, it is imperative for the mechanical processing shrinkage of the three screw granulator to shrink the shrinkage link of the plastic granulating machine. Cooling channel design, gate type and gate size may have multiple effects. For example, a small gate, such as a tube gate, is much cooler than a cone-shaped gate. Premature cooling at the gate reduces the filling time in the cavity, thereby increasing the probability of shrinkage.
For molding workers, adjusting the processing conditions is a way to solve the problem of mechanical shrinkage of plastics granulation. The filling pressure and time significantly affect the contraction. After the components are filled, the excess data will continue to be filled into the cavity to compensate for the shrinkage of the material. The filling stage is too short, which will cause the shrinkage to intensify, and eventually there will be more or larger shrinkage marks. This kind of plastic granulating mechanical shrinkage method itself may not reduce the shrinkage to the satisfactory level, but the molding worker can adjust the filling condition to improve the shrinkage mark