- The function introduction of three screw granulator
- How to look at the future development of the three screw extruder
- Structural features of three screw granulator
- General failure of three screw extruder and its elimination method
- Instructions for the use of three screw extruder
- The difference between a single screw granulator and a twin screw granulation machine
- Several points for attention in selecting plastic pelletizer
- Summary of screw knowledge parameters of twin screw granulator
- Three screw extruder granulation machine granulator appear black spots how to do
- The principle and fault maintenance of the granulator
- How to do the high temperature of the waste plastic granulator at work
- What do you need to pay attention to when using the three screw pelletizer
Shijiazhuang Xi Rong Machinery Co., Ltd.
地址:Shijiazhuang City West Development Zone of Wuji County
传真:0311-86504778
手机:13102889793
联系人:Manager Wang
邮箱:wlh88888888@163.com
What are the daily maintenance of three screw pelletizer?
Below, the three screw pelletizer manufacturers to give you a brief introduction of the three screw pelletizer daily maintenance what?
1, after the extruder is used for 500 hours, the gear or other impurities will be worn out in the gearbox. Therefore, the gear should be cleaned and the reducer should be replaced at the same time.
2, three screw pelletizer after a period of time to do a comprehensive inspection, check the tightness of all screws.
3. If you find the turn of the meter and pointer is full, check whether the contact of the thermocouple equilateral is good.
4. If the electricity is interrupted, the main drive and the heating stop, when the power supply is restored, the barrel must be reheated to the specified temperature and the extruder can be opened for a period of time.
5, the screw is only allowed to start at low speed, and the idle time does not exceed 3 minutes.
6, materials are not allowed to have debris, strictly prohibit metal and sand and other hard objects into the hopper and extruder.
7, there should be enough heating up time before heating. After reaching the set temperature, the temperature should be kept constant for 2 hours.
8, when opening the lid or suction cover, prevent foreign objects from falling into the main engine.
相关文章
- 2016-12-08What are the advantages of the three screw pelletizer
- 2016-12-08What auxiliary equipment do three screw pelletizer have?
- 2016-12-08What are the classifications and structures of the three screw pelletizer?
- 2015-12-15Maintenance common sense of three screw granulator
- 2016-11-28Maintenance knowledge of twin screw granulator and comparison with three screw extruder